HDCVI Standalone DVR User’s Manual
Figure 4-152
4.11.4.8 RAID
RAID function is for some series product such as advanced 1080P 2U RAID series only.
Right now system supports RAID0/RAID1/RAID5/RAID10. Please refer to Appendix G for
detailed information.
4.11.4.8.1 RAID Config
The RAID configuration interface is shown as in Figure 4-153. In this interface, you can
set RAID type and settings.
Create manually: Check HDD manually to crate RAID.
Create RAID: Click it to automatically create RAID.
For create RAID function, you can select the physical HDD that does not included in the
RAID group or the created disk array to create a RADI5. You can refer to the following
situations:
There is no RAID, no hotspare disk: System directly creates the RAID5 and creates
one hotspare disk at the same time.
There is no RAID, but there is a hotspare disk: System creates the RAID5 only. It
uses previous hotspare disk.
There is RAID: System cancel the previous RAID setup and then create the new
RAID5. System creates the hotspare disk if there is no one. System uses previous
hotspare disk if there is hotspare disk available.
The background will format the virtual disk.
To Next Page
Loading...
