HDCVI Standalone DVR User’s Manual
Important
Shut down the device and unplug the power cable before you install the HDD.
Always use the HDD for the surveillance product recommended by the
manufacturer.
All figurers listed below for reference only. Slight difference may be found on
the front or rear panel.
You can refer to the User’s Manual for recommended HDD brand. Please follow the
instructions below to install hard disk. This series DVR max supports 8 SATA HDDs.
Please use HDD of 7200rpm or higher.
3.3.2.1 1.5U series
This series DVR max has four SATA HDDs.
① Loosen the screws of the
upper cover.
② Place the HDD in
accordance with the four
holes in the bottom.
③ Use four screws to secure
the HDD.
④ Unfasten the HDD power
cable.
⑤ Use special data cable to
connect the HDD and the
SATA port.
⑥ Insert the HDD power cable
and then put the cover back.
Secure firmly.
3.3.2.2 2U
To Next Page
Loading...
