5
Inserting an SD Card
Twist and slide the cover on the top of the camera towards the back and then remove.
Insert the SD card into the slot and gently push until it clicks into place.
Twist and slide the cover back into place and ensure the cover is secure.
Mounting the Camera to a Wall
Determine if a junction box exists at the installation location. If not, you will need to hire a
licensed electrician to install a junction box at the location to ensure that all local codes are
met.
Cut the power to an existing light or device at the installation location at the breaker box.
Then, remove the existing device, remove any mounting plates, and disconnect the wires.
Inspect the junction box to make sure it is watertight.
Route the wires through the IPC-L26N mounting plate, then attach the mounting plate to
the junction box using the bracket screws.
Turn the adjustment knobs for the floodlights to expose the hole for the mounting screw.
Attach one end of the hook into the hole on the mounting plate and the other end to the
edge of the camera. Ensure the hook is securely attached then release the camera to free
both hands.
To Next Page
Loading...
