User’s Manual
5
3.2.2 Radar for Anti-smashing
Drill holes. Step 1
1) Drill a Φ23 mm (0.9'') circular hole (hole A) on the casing of the advertising barrier
and at a height of 68 cm (26.8'') from the ground (78 cm (30.7'') is recommended
when large trucks are frequently seen).
2) Drill two Φ5 mm (0.2'') circular holes (holes B and C). The distance between holes
A and B is 39 mm (1.5''), and the distance between holes A and C is 85 mm (3.3'').
Hole size (mm) Figure 3-5
Fix the Radar. Step 2
1) Install waterproof joints between the Radar and the casing of the barrier. See
Figure 3-6.
2) Fix the Radar to the casing through holes B and C by using screws.
3) Connect radar cables to the barrier through hole A. See Figure 3-7.
For the installation result, see Figure 3-8.
To Next Page
Loading...