User’s Manual
3
3 Installation
Tools 3.1
Hole opener, Phillips screwdriver, straight screwdriver, wire stripper, RS-485 cable, and PC.
Extra tools needed when installing radar for triggering snapshot: Impact driver, M10 drill, and
wrench.
Installation Method 3.2
The Radar, either used for triggering snapshots or anti-smashing, needs to be installed vertical
to the lane direction. Install the anti-smashing radar on the casing of the boom barrier, and
when the Radar is used for triggering snapshots, install it on a pole, with the lower side of the
Radar 0.6 m (2.0 ft) away from the ground.
Installation example Figure 3-1
When installing the Radar on the casing of the barrier, the casing must be stable (jittering
angle no more than 5°) to ensure the detection accuracy of the Radar.
When installing guardrail at one side of the lane, secure the guardrail to prevent it from
moving back-and-forth or jittering.
3.2.1 Radar for Triggering Snapshot
Install the mounting pole. Step 1
1) Install the mounting pole on the same side with the license plate recognition
camera.
2) Mark four holes on the ground according to holes of the mounting pole, and then
use M10 drill to drill four 50 mm (2.0'') holes in the ground based on the marks.
3) Use four M6 expansion screws to fix the mounting pole to the ground. Put the
cover in place.
To Next Page
Loading...