User’s Manual
13
View and modify Wi-Fi information Figure 4-6
4.2.4 Viewing Real-time Data
In the SysInfo section, tap Open, and then you can view the real-time detection data. If a target
is detected, a green dot will show at the target’s position. See Figure 4-7. If the green indicator
keeps on (meaning target is detected) after the Radar is installed, you can check whether there
is interference in the detection range according to the actual conditions near the Radar. If yes,
adjust the Min Range (see Table 4-1) to filter out the interference and ensure detection
accuracy.
To Next Page
Loading...