10
Configuration
Before configuration, install and power up all components.
IP addresses and No. of every door station (VTO) and indoor monitor (VTH) have been
planned.
Scan QR code on the cover for details.
2.6.1 Initialize the VTH
You must supply the following information before configuring the VTH:
Password
Email address (used to retrieve password)f
Power on the device.
The system displays the Device Initialization interface.
Type your Password, and then type the same password in Confirm Pwd box.
Type a valid email address.
Press OK.
The system prompts for the Quick Configuration.
To Next Page
Loading...
Need help?
General
