5
3 VTO Configuration
This chapter provides a step-by-step configuration of the VTO. Follow the instructions below to get
started.
The snapshots are for reference only and slight differences might be found in the actual web page of
the VTO depending on your model.
Configuration Tool 3.1
You can download the configuration tool VDPConfig and use it to configure and update multiple
devices. For more details, see the corresponding user's manual.
Initialization 3.2
For the first time login, you need to initialize the VTO.
Step 1 Power on the VTO.
Step 2 Go to the default IP address (192.168.1.108) of the VTO in the browser address bar, and
then press the Enter key to go to the web page of the VTO.
●
The user name is admin by default.
●
Make sure that the IP address of the PC is on the same network segment as the VTO.
Step 3 On the
Device Init
page, enter and confirm the password, and then click
Next
.
The password must consist of 8–32 non-blank characters and contain at least two types of
the following characters: Uppercase, lowercase, numbers, and special characters (excluding
' " ; : &).
Device initialization Figure 3-1
To Next Page
Loading...
Need help?
General