Dahua IPC-HDW1439V-A-IL - Page 153

Figure 5-8 Setting (snapshot time period)
2. Select a day, and the alarm type next to a period. Then set the period.
Select All or check boxes of some days to set the time period of multiple days at
one time.
You can set 6 time periods per day.
3. You can set 6 time periods per day.
Step 3 Click Save.
5.1.1.3.2 Setting Snapshot Linkage
On the alarm event setting page (such as the motion detection page), select Snapshot and set
alarm linkage snapshot.
Figure 5-9 Snapshot linkage
5.1.1.4 Relay-out Linkage
When an alarm is triggered, the system can automatically link with relay-out device.
On the alarm event setting page (such as the motion detection page), select Alarm and set Alarm
Delay.
When alarm delay is congured, alarm continues for an extended period after the alarm ends.
Figure 5-10 Relay-out linkage
5.1.1.5 Email Linkage
When an alarm is triggered, the system will automatically send an email to users.
Email linkage takes eect only when SMTP is congured. For details, see "4.6.5 SMTP (Email)".
Operation Manual
142