5.3 Setting Panoramic Calibration
The device has calibration parameters by default, and you can modify the parameters manually
when the eect is not good with default setting. Before manually calibrating a channel, clear all
default calibration parameters.
Channel 1 is a PTZ camera. You should calibrate the scene coordinates of Channel 1 and other
channels. Take Channel 2 as an example.
Procedure
Step 1 Select Setting > Event > Panoramic Calibration.
Figure 5-20 Panoramic calibration
Step 2 Select channel 2, and then select a calibration number under the video images in turns
(See Figure 5-21 ) to add calibration points to the corresponding video images. Take
Calibrate 1 as an example.
Figure 5-21 Select a calibration number
Operation Manual
150
To Next Page
Loading...
