Dahua LDH SAI200 Series - Page 32

Basic Operations 24
Network
Type
Description
WLAN
Connect your Signage to network by Wi-Fi. Click to turn on Wi-Fi first.
Then, to connect your Signage to network, you can:
Click a given Wi-Fi, type its password and click Connect.

Or you can add a Wi-Fi manually: click to display the Add Network

interface. Then type Network SSID and select Security from None, WEP,
WPA/WPA2 PSK and 802.1x EAP. Click Save to finish configuration.
4G
You can connect a 4G mobile network card to your device and select Data
Enabled to finally get your device networked.
VPN
Connect your device to VPN. Then your device can get programs from VPN.
4.6.1.2.2 Configuring Whitelist
Configure the IP that are allowed to access the Signage, and only IP addresses in the whitelist
can access the Signage. This is to enhance data security.
In main menu, click Settings > Network Setting > Whitelist.
Step 1
The Whitelist interface is displayed.
Click to enable whitelist and make it take effect officially.
Step 2
Add an IP address to your whitelist.
Step 3
1) Click .
The Add Whitelist interface is displayed. See Figure 4-8.
The add whitelist interface
Figure 4-8
2) Type an IP address.
3) Click Confirm.
The IP address you have added is displayed.
Repeat Step 3 to add multiple IP addresses to your whitelist.
4.6.1.3 Connecting Signage to platform
Connect the Signage to the platform. Then you can use the platform to send programs.
To use the platform to send programs, stop playing programs from the USB drive first.
Preparation