Dahua LDH SAI200 Series - Page 37

Basic Operations 29
The add device interface
Figure 4-14
Configure the parameters. See Table 4-4.
Step 4
Table 4-4 Parameter description
Parameter
Description
Protocol
According to the connection method you want between the camera and your
Signage, you can select from IPC, DSS, PSS and IVSS.
If you want to connect the camera directly to your device, you can select

IPC.
If you want to connect the camera to your device by the third-party

platform or device, you can select DSS, PSS or IVSS.
IP Address
Address of your camera or the platform.
User Name
You need to fill in the two items when you select IPC or IVSS as the Protocol.
Password
Port
Port number when you log in your camera or the platform.
Channel
You need to configure this parameter only when you select IPC or IVSS as the
Protocol.
When you select IPC as the Protocol, you directly connect only one IPC

to the device. Fill 1 in the Channel box.
When you select IVSS as the Protocol, to determine the channel number

you want:
1. Type http://XXX /cgi-bin/LogicDeviceManager.cgi?action=getCameraAll
(“XXX” refers to the IP address of IVSS) in your browser to view the
channels.
2. Determine the channel which you want to add to your device.
3. Add 1 to the channel’s UniqueChannel value.
4. Fill the new value in the Channel box.
Registration
Code
You need to configure this parameter only when you select DSS or PSS as the
Protocol.
Registration code given by the DSS platform or Smart PSS client side to the
Signage.