377
5.10.3.1.3 Tampering
The tampering interface is shown as in Figure 5-66.
After analysis video, system can generate a tampering alarm when the detected moving signal reached
the sensitivity you set here.
For detailed setups, please refer to chapter 5.10.3.1.1 motion detect for detailed information.
Figure 5-66
5.10.3.1.1 Scene Change
From main window->Setup->Event->Video detect->Scene change, the video diagnosis interface is shown
as in Figure 5-67.
Figure 5-67
For detailed setups, please refer to chapter 5.10.3.1.1 motion detect for detailed information.
5.10.3.1 IVS Plan
The smart plan is for the smart network camera. If you do not set a rule here, you cannot use the
intelligent functions in IVS (Chapter 5.10.3.2), Face detection (Chapter 5.10.3.3) and People counting
(Chapter 5.10.3.4) when you are connecting to a smart network camera.
To Next Page
Loading...
