2 Installation
2.1 Install Device
It introduces two installation methods as embedded box and direct installation.
Warning:
Avoid the indoor unit installed in adverse environments, such as condensation and high
temperature environment, oil and dust environment, chemically aggressive environments,
direct sunlight environment.
After power is found abnormal, should immediately unplug the network cable, turn off the
power. After troubleshooting before power again.
Project installation, debugging shall be performed by a professional team, in case of
equipment failure, do not disassemble repair yourself, please contact product sales
departments.
2.1.1 Embedded Box
Embedded box has 86-box and metal box, and their corresponding relationships are as
follows:
Installation Step
Step 1. Embed 86-box into wall.
Step 2. Fix installation bracket on 86-box with screws.
Step 3. Fix device unit on installation bracket with buckle.
Note:
Distance from device center to ground is recommended to be 1400mm-1600mm.
To Next Page
Loading...
Need help?
General
