Dahua VTH5221D Setup Instruction

4. Launch Internet Explorer and enter the VTO's default IP address into the URL address
bar: 192.168.1.110. If you cannot see the web page load on this default IP, then please press
and hold the reset button located on the back side of the VTO for 15 seconds while the
device is powered on. Once at the login page please enter the default username (admin) and
password (admin).
5. After the login page please select Network Config on the left side. Under the TCP/IP tab
please input the desired network configuration under ETH2, which is the wifi interface. For
this exercise, the network uses a 192.168.2.x scheme, and the device will be configured on

Dahua VTH5221D Specifications

General

Brand	Dahua
Model	VTH5221D
Category	Intercom System
Language	English