Dahua XVR4108C User Manual

517
Figure 5- 36
5.10.1.4 Channel Name
Here you can set channel name. See Figure 5- 37.
Please note this function is for analog channel only. The digital channel name here is
read-only.
Figure 5- 37
5.10.1.5 Channel Type
It is to set channel type.

For analog channel (CVBS signal or HDCVI HD signal), you can select coaxial cable
or UTP cable. Please check first and then save setup. There is no need to reboot.

You can switch analog channel type to digital channel type if you want to connect to
network camera. The IP channel shall start from the last channel. System needs to
reboot to activate current setup.
Note
If there is no connected channel, the channel type here just displays previous connection
record. System supports self-adaptive after camera connection.
The interface is shown as in Figure 5- 38 (XVR series product) and Figure 5- 39 (HCVR
series product).
Important notice about XVR series product:

Nowadays, there are mainly two analog signal types on today market: analog
standard definition (CVBS) and analog HD (CVI, AHD or Other). For XVR series
product, each channel supports all types of signal connection (analog signal/IP
signal). For analog signal connection, the default setup is AUTO, that is to say, no

Dahua XVR4108C Specifications

General

Brand	Dahua
Model	XVR4108C
Category	DVR
Language	English