Figure 5- 76
Note
Video diagnosis alarm can trigger PTZ preset, tour, and pattern.
For detailed setups, please refer to chapter 5.10.3.1.1 motion detect for detailed
information.
Note
Right now, the IVS function max supports 10 rules.
Once any object violate the rule, the DVR can trigger an alarm and alert you as the
specified alarm mode.
From main menu->Setup->Event->IVS, enter IVS interface. See Figure 5-77.
Please follow the steps listed below.
Step 1 Please select a channel from the dropdown list.
Step 2 Click and then select corresponding rule.
Step 3 Set rule type and set corresponding parameters.
Step 4 Check the box to enable the rule.
Step 5 Click OK button to save current setup.
To Next Page
Loading...
Need help?
General