Figure 5- 77
System generates an alarm once there is any object crossing the tripwire in the specified
direction. Please use according to your actual situation.
Note
The tripwire function is valid once your connected network camera or your DVR
supports this function.
If you want to use the IVS function of the network camera, please make sure your
connected network camera supports this function.
Step 1 From main menu->Setup->Event->IVS->Tripwire, click to add the rule and
select the rule type as Tripwire.
Note
Double click to change a rule name.
Step 2 Check the Tripwire box to enable tripwire function. See Figure 5- 78.
To Next Page
Loading...
Need help?
General