Dahua XVR5108C-I3 - Page 30

25
Parameter
Description
Show Message
Select the
Show Message
check box to enable a pop-up message in
your local host PC.
Report Alarm
Select the
Report Alarm
check box to enable the system to upload the
alarm signal to the network (including alarm center) when an alarm
event occurs.
Send Email
Select the
Send Email
check box to enable the system to send an
email notification when an alarm event occurs.
To use this function, make sure that the email function is enabled in
Main Menu
>
NETWORK
>
EMAIL
.
Record Channel
Select the channel(s) that you want to record. The selected channel(s)
starts recording after an alarm event occurs.
The recording for motion detection and auto recording function must
be enabled.
PTZ Linkage
Click
Setting
to display the PTZ interface.
Motion Detect can only activate PTZ preset.
Post Record
Set a length of time for the Device to delay turning off recording after
the alarm is cancelled. The value ranges from 10 seconds to 300
seconds, and the default value is 10 seconds.
Tour Select the
Tour
check box to enable a tour of the selected channels.
Picture Storage
Select the
Snapshot
check box to take a snapshot of the selected
channel.
To use this function, select
Main Menu
>
CAMERA
>
Encode
>
Snapshot
, in the
Type
list, select
Event
.
Sub Screen
Select the check box to enable the function. When an alarm event
occurs, the extra screen outputs the settings configured in
Main
Menu
>
DISPLAY
>
Tour
>
Sub Screen
.
●
Not all models support this function.
●
To use this function, extra screen shall be enabled.
Buzzer Select the check box to activate a buzzer noise at the Device.
Log Select the check box to enable the Device to record a local alarm log.
Alarm Tone
Select to enable audio broadcast/alarm tones in response to a motion
detection event.
White Light Select the check box to enable the white light alarm of the camera.
Siren Select the check box to enable the sound alarm of the camera.
Step 4 Click Apply to save configuration.