Daikin AGZ 025D - Lcd Display

62 AGZ 025D through 190D OMM 1166-1
LCD Display
Table 16, Display Data
No
Name
Display
Content
1
Operation
Mode Menus
MODE
Displayed when in Mode Selection.
MONITR
Displayed when in Monitor Mode.
VERIFY
Indicates the Verify Menu
PRMSET
Displayed when in Parameter Setting Mode.
A.TUNE
Displayed during Auto-Tuning.
SETUP
Displayed when in Setup Mode.
2
DriveWorksEZ
Function
Selection
DWEZ
Displayed when DriveWorksEZ is set to enable. (A1-07 = 1 or 2)
3
Mode Display
Area
DRV
Displayed when in Drive Mode.
PRG
Displayed when in Programming Mode
4
Ready
Rdy
Indicates the drive is ready to run.
5
Data Display
—
Displays specific data and operation data.
6
FrequencyRef
erence
Assignment
<1>
OPR
Displayed when the frequency reference is assigned to the LCD Operator
Option.
AI
Displayed when the frequency reference is assigned to the Analog Input of the
drive
COM
Displayed when the frequency reference is assigned to the MEMOBUS/Modbus
CommunicationInputs of the drive
OP
Displayed when the frequency reference is assigned to an Option Unit of the
drive.
RP
Displayed when the frequency reference is assigned to the Pulse Train Input of
the drive
7
LO/RE Display
<2>
RSEQ
Displayed when the run command is supplied from a remote source.
LSEQ
Displayed when the run command is supplied from the operator keypad.
RREF
Displayed when the run command is supplied from a remote source.
LREF
Displayed when the run command is supplied from the operator keypad
8
Function Key
1(F1)
JOG
Pressing [F1} executes the Jog function.
HELP
Pressing [F1] displays the Help menu.
←
Pressing [F1] scrolls the cursor to the left.
HOME
Pressing [F1] returns to the top menu (Frequency Reference).
ESC
Pressing [F1] returns to the previous display
9
FWD/REV
FWD
Indicates forward motor operation.
REV
Indicates reverse motor operation.
10
Function Key 2
(F2)
FWD/REV
Pressing [F2] switches between forward and reverse
DATA
Pressing [F2] scrolls to the next display
Pressing [F2] scrolls the cursor to the right
RESET
Pressing [F2] resets the existing drive fault error