Daikin AGZ 130D - VFD Interface (HMI)

OMM 1166-1 AGZ 025D through 190D 61
VFD Interface (HMI)
The HMI is located in the lower left-hand
corner of the unit control panel. It is used to
view data including fault and alarm
information. No operator intervention on
this control is required for normal unit
operation.
Table 14, Display Key Functions
Table 15, Display Key Functions
No.
Display
Name
Function
1
Function
Key(F1, F2)
The functions assigned to F1 and F2 vary depending on the currently displayed menu.
The name of each function appears in the lower half of the display window.
2 3
ESC Key
RESET Key
• Returns to the previous display.
• Moves the cursor one space to the left.
• Pressing and holding this button will return to the Frequency Reference display.
3
• Moves the cursor to the right.
• Resets the drive to clear a fault situation.
4
RUN Key
Starts the drive in LOCAL mode.
5
Up Arrow Key
Scrolls up to display the next item, select parameter numbers, and increment setting
values.
6
Down Arrow
Key
Scrolls down to display the next item, select parameter numbers, and increment
setting values.
7
STOP Key
Stops drive operation.
8
ENTER Key
• Enters parameter values and settings.
• Selects a menu item to move between displays
9
LO/RE
Selection Key
Switches drive control between the operator (LOCAL) and an external source
(REMOTE)for the Run command and frequency reference.
10
RUN Light
Lit while the drive is operating the motor.
11
LO/RE Light
Lit while the operator is selected to run the drive (LOCAL mode).
12
ALM LED Light
Refer to ALARM (ALM) LED Displays on page 63