ESIE09-08A Field Setting
Test Operation 119
The numbers in the "No." column represent the number of times to press the SET (BS2)
button.
Remark: Pump down operation is ONLY ALLOWED when the refrigerant charge is
less than
4,5kg.
No. Setting item Description
21
Refrigerant recovery /
vacuuming mode
setting of R-410A
circuit
Sets to refrigerant recovery or vacuuming mode.
61
Automatic pump
down operation
An automatic pump down operation which will collect all
refrigerant from the field piping and indoor unit in the outdoor
unit.
b. “Setting mode 2”
<Selection of setting items>
<Selection of setting conditions>
Push and hold the MODE (BS1)
button for 5 seconds and set to
“Setting mode 2”.
Push the SET (BS2) button and set
the LED display to a setting item
shown in the table on the right.
↓
Push the RETURN (BS3) button and
decide the item. (The present setting
condition is blinked.)
Push the SET (BS2) button and set
to the setting condition you want.
↓
Push the RETURN (BS3) button and
decide the condition.
Push the RETURN (BS3) button and
set to the initial status of “Setting
mode 2”.
∗ If you become unsure of how to
proceed, push the MODE (BS1)
button and return to setting mode 1.
(V2764)
To Next Page
Loading...
