Daikin BACnet - Default Chapter; Table of Contents

IM 1040 • VAV ACTUATOR 2 www.DaikinApplied.com
Table of ConTenTs
Table of ConTenTs
Introduction..................................3
Revision History .............................3
Reference Documents ........................3
Limited Warranty .............................3
Notice .....................................3
General Information ..........................3
Hazard Identication Messages .................3
Start-Up Procedures...........................4
Before you begin .............................4
Communication and DO indicators ...............4
Setting controller address ......................4
Setting the application.........................4
Enabling actuators ...........................5
Specifying motor setup ........................5
Verifying actuator setup........................5
Setting the number of heat stages or valves........5
Selecting automatic calibration option.............6
Setting room temperature setpoints ..............6
Setting override time ..........................6
Enabling Wall Switch..........................6
Setting Duct Area ............................6
Setting ow coefcient ........................7
Setting airow setpoints .......................7
Setting room temperature offset (optional) .........7
Performing the automated checkout ..............8
Conguring BACnet parameters .................8