2 ■English
Names and functions of the
operating section
See gure 1, (gure 1B shows the remote controller with
front cover opened)
1 DISPLAY “
” (SIGNAL TRANSMISSION)
This lights up when a signal is being transmitted.
2 DISPLAY “
” “ ” “ ” “ ” “ ” (OPERATION
MODE)
This display shows the current OPERATION MODE.
3 DISPLAY “
” , “ ” (SET TEMPERATURE)
This display shows the set temperature.
4 DISPLAY “
” (PROGRAMMED TIME)
This display shows PROGRAMMED TIME of the system
start or stop.
5 DISPLAY “
” (SWING FLAP)
Refer to “AIR FLOW DIRECTION ADJUST” on page 5.
6 DISPLAY “
” “ ” “ ” (FAN SPEED)
The display shows the set fan speed.
7 DISPLAY “
” (INSPECTION/TEST OPERATION)
When the INSPECTION/TEST OPERATION BUTTON is
pressed, the display shows the system mode is in.
8 ON/OFF BUTTON
Press the button and the system will start. Press the
button again and the system will stop.
9 FAN SPEED CONTROL BUTTON
Press this button to select the fan speed, LOW, MEDIUM
or HIGH, of your choice.
10 TEMPERATURE SETTING BUTTON
Use this button for SETTING TEMPERATURE.
11 TIMER MODE START/STOP BUTTON
Refer to “TIMER MODE START/STOP” on page 6.
12 TIMER RESERVE/CANCEL BUTTON
Refer to “PROGRAMMING TIME” on page 6.
13 AIR FLOW DIRECTION ADJUST BUTTON
Refer to “AIR FLOW DIRECTION ADJUST” on page 5.
14 OPERATION MODE SELECTOR BUTTON
Press this button to select OPERATION MODE.
15 FILTER SIGN RESET BUTTON
Refer to the section of MAINTENANCE in the operation
manual attached to the indoor unit.
16 INSPECTION/TEST OPERATION BUTTON
This button is used only by qualied service persons for
maintenance purposes.
See gure 3, (receiver on decoration panel)
17 EMERGENCY OPERATION SWITCH
This switch is readily used if the remote controller does
not work.
18 RECEIVER
This receives the signals from the remote controller.
19 OPERATION LAMP (Red)
This lamp stays lit while the air conditioner runs. It blinks
when the unit is in trouble.
20 TIMER LAMP (Green)
This lamp stays lit while the timer is set.
21 AIR FILTER CLEANING TIME INDICATOR LAMP (Red)
Lights up when it is time to clean the air lter.
22 DEFROST LAMP (Orange)
Lights up when the defrosting operation has started.
NOTE
For the sake of explanation, all indications are
shown on the display in gure 1 contrary to
actual running situations.
If the AIR FILTER CLEANING TIME
INDICATOR lamp lights up, clean the air lter
as explained in the operation manual provided
with the indoor unit.
After cleaning and reattaching the air lter,
press the FILTER SIGN RESET button
on the remote controller. The AIR FILTER
CLEANING TIME INDICATOR lamp on the
receiver will go out.
The DEFROST lamp will blink when the power
is turned on. This is not a malfunction.
01_EN_3P444561-1.indd 2 7/12/2016 11:18:34 AM
To Next Page
Loading...
