English 17
3
Cool
Return Setting
Set to
Cool
74F
Press the Mode button on the remote ●
controller of the indoor unit designated
as the cool/heat changeover master (the
remote controller not displaying the
MASTER
CONTROLLED
icon) repeatedly until the desired
mode is selected. The display will
change to “Fan”, “Dry”, “Auto”, “Cool”,
“Heat” each time the button is pressed.
Simultaneously, the other indoor units on
●
the system will follow suit and change
modes to refl ect the new mode selected
at the changeover master remote
controller.
Cool / Heat Mode Selection Availability
“Cool”, “Heat” and “Auto” are all only available for selection on the cool/heat changeover master ●
indoor unit. The following table indicates the available operating modes of the other indoor units
on the system based upon the selected mode of the master indoor unit.
When the master indoor
unit is set to
The other indoor units in the system can be set to
Cool Dry Heat Fan
Cool mode
Dry mode
Heat mode
Fan mode
Auto mode (Cooling operation)
Auto mode (Heating operation)
01_EN_3P243520-2C.indd 1701_EN_3P243520-2C.indd 17 8/27/2009 1:48:36 PM8/27/2009 1:48:36 PM
To Next Page
Loading...
