EasyManua.ls Logo

Daikin DC80VC - Circulation Air Filters

Daikin DC80VC
52 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
25
CIRCULATION A IR F ILTERS
One of the most common causes of a problem in a forced air
heating system is a blocked or dirty filter. Circulating air filters
must be inspected monthly for dirt accumulation and replaced
if necessary. Failure to maintain clean filters can cause prema-
ture heat exchanger failure.
A new home may require more frequent replacement until all
construction dust and dirt is removed.
Upflow / Horizontal
Model s
Minimum Recommended Filter Size^
DM80VC0603B* 1 - 16 X 25 Side or 1 - 14 X 24 Bottom Return
DM80VC0604B* 1 - 16 X 25 Side or 14 X 24 Bottom Return
DM80VC0803B* 1 - 16 X 25 Side or Bottom Return
DM80VC0804C* 1 - 16 X 25 Side or Bottom Return
DM80VC0805C 1 - 16 X 25 Side or Bottom Return¹
DM80VC0805D*¹ 1 - 16 X 25 Side or Bottom Return¹
DM80VC1005C* 2 - 16 X 25 Side or 1 - 20 X 25 Bottom Return
Downflow / Horizontal
Mode l s
DC80VC0603B* 2 - 10 X 20 or 1 - 16 X 25 Top Return
DC80VC0803B* 2 - 10 X 20 or 1 - 16 X 25 Top Return
DC80VC0805C* 2 - 14 X 20 or 1 - 20 X 25 Top Return
DC80VC1005C* 2 - 14 X 20 or 1 - 20 X 25 Top Return
^ Larger filters may be used, filters may also be centrally located
1 = use 2 - 16 X 25 fi lters and two si de returns or 20 X 25 filter
on bottom return if furnace is connected to a cooling unit
over 4 tons nominal capacity
Consider installing an air cleaner with deep-pleated media filter
at the time of furnace installation. A deep-pleated filter with a
MERV rating of 8 (minimum) will often provide better filtration to
protect equipment and the air distribution system than a stan-
dard 1" filter and often has lower static pressure loss than a 1"
filter. Also a deep-pleated filter will typically require less fre-
quent replacement intervals. Avoid using highly restrictive 1"
filters which produce static pressure loss greater than .25" W.C.
In some installations the minimum filter size required (consult
filter sizing chart ) will not lend itself to a filter installation on the
side of the furnace. The installation of a centrally installed air
cleaner cabinet or a return duct filter installation may offer more
practicality.
Clean Comfort™ brand MERV 11 air cleaners have 5¼” media
filters and are available in the following configurations. Consult
your distributor for information on our complete line of IAQ Clean
Comfort™ products.

Table of Contents

Related product manuals