Procedure for Software Upload Hydrobox ESIE11-05
200 Service Procedure
Step 4 Connect serial port end of the cable to the laptop.
Step 5 Close the front plate of the hydrobox unit.
Step 6 Put power supply to the hydrobox unit by switching ON the main circuit breaker.
Step 7 (Programming of software can now start.)
Browse to the executable FlashSta.exe and double-click on the file “FlashSta.exe”:
Step 8 Programming of software
1. Internal flash memory.
2. Select correct port.
3. Click on “OK”.
After clicking on “OK”, following window appears: “ID Check”.
This is the window that refers to the software file.
To Next Page
Loading...
