SiUS122226E Functions for Wall Mounted / Floor Standing Type
Part 4 Functions and Control 75
2.14 Other Functions
2.14.1 Hot-Start Function
In order to prevent the cold air blast that normally occurs when heating operation is started, the
temperature of the indoor heat exchanger is detected, and the airflow is either stopped or
significantly weakened resulting in comfortable heating.
The cold air blast is prevented using similar control when defrost control starts or when the
thermostat is turned ON.
2.14.2 Signal Receiving Sign
When the indoor unit receives a signal from the remote controller, the unit emits a signal receiving
sound and the operation lamp blinks.
2.14.3 Indoor Unit ON/OFF Switch
ON/OFF switch is provided on the display of the unit.
Press ON/OFF switch once to start operation. Press once again to stop it.
ON/OFF switch is useful when the remote controller is missing or the battery has run out.
In the case of multi system operation, there are times when the unit does not activate with
ON/OFF switch.
Operation mode Temperature setting Airflow rate
AUTO 25°C (77°F) Automatic
CTXS/FTXS Series FTXR Series
FVXS Series
(R23924)
ON/OFF switch
(R23923)
ON/OFF switch
To Next Page
Loading...
Need help?
General
