SiK401004_A
39 FUNCTION CONTROL
3.2 Buttons
3.2.1 Silk Screen of Buttons
Fig.3.2.1 Silk screen of buttons
3.2.2 Instruction to Function of Buttons
No. Description Function of Button
1 Enter/Cancel
(1) Function selection and canceling;
(2) Press it for 5s to enter the outdoor ambient temperature display.
2 ▲
6 ▼
(1) Temperature setting of indoor unit, range :16~30C
(2) Timer setting, range:0.5-24hr
(3) Switchover between quiet/auto quiet
3 Fan Setting of high/middle/low/auto fan speed
4 Mode Setting of cooling/heating/fan/dry mode of indoor unit
5 Function
Switch over among these functions of
air/sleep/turbo/save/e-heater/blow/quite
7 Timer Timer setting
8 On/Off Turn on/off indoor unit
4 Mode
and
2 ▲
Memory function
Press Mode and ▲ for 5s under off-state of the unit to enter/cancel
key memory function (If memory is set, indoor unit will resume
original setting state after power failure and then power recovery. If
not, indoor unit is defaulted to be off after power recovery. Memory
function is defaulted to be off before outgoing.)
2 ▲
and
6 ▼
Lock
Upon startup of the unit without malfunction or under off-state of the
unit, press ▲ ▼ key at the same time for 5s in to lock state. In this
case, any other buttons won’t respond the press. Repress ▲ ▼ key
for 5s to quit lock state.
4 Mode
and
5 Function
Enquiry and
setting of address
of wired controller
Under the off-state of the unit, press Mode/Function button for 5
seconds to set the address.