SiK401004_A
49 FUNCTION CONTROL
3.4.9 Turbo Function Setting
Turbo function: The unit at high fun speed can realize quick cooling or heating so that
room temperature can quickly approach setting temperature.
In cooling or heating mode, press Function button till the unit enters turbo function and
then press Enter/Cancel button to turn on turbo function.
During turbo function, press Function button till the unit enters turbo function and then
press Enter/Cancel button to cancel turbo function.
Turbo function setting is shown in Fig.3.4.9:
Fig.3.4.9 Turbo Function Setting
Note:
1. Turbo function will be turned off after power failure and then recovery. In dry, fan and
auto mode, turbo function can not be set and turbo mark won’t be displayed.
2. Turbo function will be automatically canceled after setting of quiet function.
3.4.10 Save Function Setting
Energy Saving Function: Energy saving result that the air conditioner runs in smaller
temperature range is realized by setting lower limited value of
setting temperature in cooing or dry mode and upper limited
value in heating mode.
Energy Saving Setting for Cooling
Under on-state and in cooling or dry mode of the unit, press Function button into
energy saving function, SAVE blinking .Press ▲ or ▼ button to adjust lower limited
value of setting temperature in cooing mode. After that press Enter/Cancel button to
turn on energy saving function for cooling.
Energy Saving Setting for Heating
Under on-state and in heating mode of the unit, press Function button into energy
saving function, SAVE blinking. Press Mode button into energy saving function for
heating and then press ▲ or ▼ button to adjust upper limited value of setting
To Next Page
Loading...
Need help?
General
