Daikin FFQ-Q Series - Page 168

Option List EDUS091617
166 Split Type Air Conditioners FFQ-Q Series
Method of wiring processing
•
Connect wires with the control box. (Refer to the installation manual attached to the adaptor.)
•
After connecting wires with the control box, clamp wires by using the cord stickers 5 and the clamp 3 as shown in the
below drawing.
Clamp 3
Cord sticker 5
Attach the lid of installation box
Attach the lid of installation box 2 to indoor unit with two screws. If two adaptors are installed, the second adaptor is attached
to side of first one.
Lid of installation box 2
for second PCB
Lid of installation box 2
for first PCB
Screw 4
Screw 4
Installation box 1
Lid of installation box 2
Put the installation box 1
into the lid of installation box 2
Attach the installation box
Attach the installation box 1 into the lid of installation box 2 with the screw.
1P107687-1D