Troubleshooting ESIE05-04
3ā6 Part 3 ā Troubleshooting
1.3.1 Equipment does not operate
Applicable Model All models of SkyAir series
Error Detection
Method
Error Generating
Condition
Possible Causes
Q Fuse blown or disorder of contact in operation circuit
Q Faulty operation switch or contact point
Q Faulty high pressure switch
Q Faulty magnetic switch for fan motor
Q Activation or fault of overcurrent relay for fan motor
Q Faulty overcurrent relay for compressor
Q Faulty compressor protection thermostat
Q Insufficient insulation in electric system
Q Faulty contact point of magnetic switch for compressor
Q Malfunction of compressor
Q Defective remote controller or low batteries (wireless)
Q Check if address is set correctly on wireless R.C.