ESIE05-04 Disassembly and Maintenance
Part 5 ā Disassembly and Maintenance 5ā85
1.13.3 Removal of Horizontal Blade
Warning Be sure to wait 10 minutes or more after turning off all power supplies before disassembling work.
Procedure:
Step Procedure Points
1 Gently bend the support
plate located at the
center of the horizontal
blade, and detach the
center shaft.
(Two shafts provided
on Types 140 and
160.)
2 Then gently bend the
center of the horizontal
blade, and take both the
end shafts out of their
bearings.
Q When removing the horizontal
blade from the bearings at
both ends, be careful not to
get the blow port thermal
insulation scratched.
Reassembling precautions
1 The shaft at the right end
of the horizontal blade is
cut in D shape. Fit this
D-shaped end to the
D-profiled bearing.
Reattach the horizontal
blade at the right side
first.
To Next Page
Loading...
