Daikin FT35CV1A - ON Timer Operation

15
■
To use ON TIMER operation
• Check that the clock is correct. If not, set the
clock to the present time.
(page 9.)
1. Press “ON TIMER button”.
is displayed.
blinks.
2. Press “TIMER Setting button”
until the time setting reaches the
point you like.
• Every pressing of either button increases
or decreases the time setting by
10 minutes. Holding down either button
changes the setting rapidly.
3. Press “ON TIMER button” again.
• The TIMER lamp lights up.
■
To cancel ON TIMER
operation
4. Press “CANCEL button”.
• The TIMER lamp goes off.
■
To combine ON TIMER and OFF TIMER
• A sample setting for combining the two timers is shown below.
ATTENTION
■
■■
■
In the following cases, set the timer again.
• After a breaker has turned OFF.
• After a power failure.
• After replacing batteries in the remote controller.
C
TEMP
ON/OFF
MODE
ON
OFF
TIMER
FAN
SWING
CANCEL
POWERFUL
2
4
1, 3
See P6 for button names.
ON
OFF
Display
(Example)
Present time: 11:00 PM
(The unit operating)
OFF TIMER at 0:00 a.m.
ON TIMER at 7:00 a.m.
Combined
01_EN_3P132108-4F.fm Page 15 Monday, June 27, 2005 5:38 PM