EasyManua.ls Logo

Daikin FT50GAVE - Preparation Before Operation; Remote Controller Setup

Daikin FT50GAVE
18 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
7
Preparation Before Operation
Remote controller
Setting the batteries
1
Press with a finger and slide the
front cover to take it off.
2
Set two dry batteries (AAA).
3
Set the front cover as before.
This will cause the figures on the display
to flash. Set the clock at this point.
+
+
2
3
1
Position + and
correctly!
Receiver
Operating the remote controller
To use the remote controller, aim the
transmitter at the indoor unit. If there is
anything to block signals between the unit
and the remote controller, such as a curtain,
the unit will not operate.
Do not drop the remote controller. Do not get it wet.
The maximum distance for communication is about 7 m.
To fix the remote controller
holder on the wall
1
Choose a place from where the signals
reach the unit.
2
Fix the holder to a wall, a pillar, etc. with the
screws supplied with the holder.
3
Place the remote control in the remote
control holder.
ATTENTION
About batteries
When replacing the batteries, use
batteries of the same type, and replace
the two old batteries together.
When the system is not used for a long
time, take the batteries out.
When the operation display screen of the
remote controller is hard to see and the
reception become hard, replace the
batteries with new AAA batteries.
The attached batteries are provided for
the initial use of the system.
The usable period of the batteries may be
short depending on the manufactured
date of the air conditioner.
ATTENTION
About the remote controller
Never expose the remote controller to
direct sunlight.
Dust on the signal transmitter or receiver
will reduce the sensitivity. Wipe off dust
with soft cloth.
Signal communication may be disabled if
an electronic-starter-type fluorescent lamp
(such as inverter-type lamps) is in the
room. Consult the shop if that is the case.
If the remote control signals happen to operate
another appliance, move that appliance to
somewhere else, or consult the shop.
Remote
controller
holder
Set.
To remove, pull it upwards

Related product manuals