Do you have a question about the Daikin FTE50KV1 and is the answer not in the manual?
Procedure for removing the air filters from the indoor unit, involving opening the front panel and unfastening hooks.
Procedure to remove titanium apatite photocatalytic air-purifying filters by unfastening hooks and pulling the filter out.
Procedure for removing the front panel by releasing shafts after opening it further than its normal stop position.
Procedure to remove the service cover by unscrewing it and detaching it from the unit.
Procedure to remove the front grille by first removing the service cover and then unscrewing and unfastening hooks.
Procedure to remove horizontal blades by releasing shafts, sliding the blade, and unfastening the right shaft.
Procedure to remove vertical blades by releasing shafts, unfastening hooks, and pulling the blades rightward.
Procedure to remove the electrical box by unscrewing plates, cutting clamps, and disconnecting wires and connectors.
Procedure to remove PCBs by unfastening hooks and disconnecting connectors from the signal receiver unit.
Procedure to remove the swing motor for horizontal blades by unscrewing and detaching the motor assembly.
Procedure to remove the swing motor for vertical blades by removing the swing shaft and detaching the motor assembly.
Procedure to disconnect refrigerant piping by unscrewing flare nuts for gas and liquid piping after handling the drain hose.
Procedure to detach the indoor unit from the installation plate after disconnecting refrigerant piping.
Procedure to remove the indoor heat exchanger by unfastening hooks on the left and right sides and lifting it out.
Procedure to remove the right side plate by unscrewing and lifting it off the unit.
Procedure to remove the fan motor and rotor, involving removing fixing plates, screws, and the motor itself.
Procedure to remove the left side plate by unscrewing it from the unit.
| Brand | Daikin |
|---|---|
| Model | FTE50KV1 |
| Category | Air Conditioner |
| Language | English |