Need help?Do you have a question about the Daikin FTE50KV16 and is the answer not in the manual?
Procedure to detach air filters from the indoor unit by opening the front panel and unfastening hooks.
Steps to remove titanium apatite photocatalytic air-purifying filters by unfastening hooks.
Procedure to release and remove the front panel by sliding and unfastening shafts.
Instructions to remove the service cover by unscrewing it.
Steps to detach the front grille by removing screws and unfastening hooks.
Procedure for removing horizontal blades by releasing shafts and sliding them.
Steps to detach vertical blades by releasing shafts and unfastening hooks.
Steps to remove the electrical box, including disconnecting wires and removing screws.
Procedure to remove printed circuit boards (PCBs) from the signal receiver unit.
Instructions to remove the swing motor for horizontal blades by unscrewing it.
Steps to detach the swing motor for vertical blades, including shaft and assembly removal.
Procedure to disconnect refrigerant piping, including drain hose and flare nuts.
Steps to detach the indoor unit from its installation plate.
Procedure to remove the indoor heat exchanger by unfastening hooks and widening piping.
Steps to remove the right side plate by unscrewing it for access.
Procedure to remove the fan motor and rotor by detaching fixing plates and screws.
General| Brand | Daikin |
|---|---|
| Model | FTE50KV16 |
| Category | Air Conditioner |
| Language | English |
To Next Page
