Need help?Do you have a question about the Daikin FTE50NRV16 and is the answer not in the manual?
Steps for removing air filters, including hook release and optional filter removal.
Steps for removing the front panel by releasing shafts and pushing it to the side.
Steps to release the center shafts and the left shaft of the horizontal blade.
Steps to unfasten hooks and remove the vertical blade assemblies from the unit.
Steps for removing the front grille by unscrewing it and unfastening the top hooks.
Steps to remove the screw, service cover, terminal board, wire fixture, and electrical box cover.
Steps to remove the thermistor, disconnect 3 connectors, and lift out the electrical box.
Steps to remove the terminal board screw, release wires, and disconnect the control PCB connector.
Steps to unfasten hooks, disconnect PCB connector, and remove the swing motor.
Steps for removing drain hose, piping, screws, and detaching the indoor unit from the plate.
Steps to remove screws, right side plate, and the fan rotor screw.
Steps to unfasten hooks, release the fan rotor from its groove, and remove the fan motor.
General| Cooling Capacity | 5.0 kW |
|---|---|
| Refrigerant | R32 |
| Indoor Unit Dimensions (W x H x D) | 990 x 298 x 233 mm |
| Outdoor Unit Dimensions (W x H x D) | 845 x 595 x 300 mm |
| Power Supply | 230V / 50Hz / 1 Phase |
To Next Page
