Si18-201
Removal Procedure 311
Part 10
Part 10Part 10
Part 10
Removal Procedure
Removal ProcedureRemoval Procedure
Removal Procedure
1. For BPMK928B42 · 43 ........................................................................312
1.1 Installation of Indoor Unit......................................................................312
1.2 Opening of Electrical Box Cover and Removal of PCB Mount.............313
1.3 Removal of Motorized Valve ................................................................315
1.4 Removal of Thermistor.........................................................................318
2. Outdoor Unit........................................................................................320
2.1 Removal of Outer Panels .....................................................................320
2.2 Removal of PCB and Electrical Box.....................................................321
2.3 Removal of Propeller Fans and Fan Motors.........................................329
2.4 Removal of Thermistor.........................................................................331
2.5 Removal of Motorized Valve ................................................................332
2.6 Removal of Sound Insulation ...............................................................334
2.7 Removal of Compressor.......................................................................336
2.8 Removal of 4-way Valve.......................................................................338
3. Indoor Unit...........................................................................................342
3.1 Refer following table for indoor unit removal procedure.......................342
The RMK140JAVM specifications are special. Refer to <RMK140JAVM's
important points> (on page ii) for the changes in contents.
To Next Page
Loading...
