Daikin FTKM18PVMK - Preparation before Operation

9
Read Before Operation
Preparation Before Operation
To insert the batteries
1. Slide the front cover to take it off.
2. Insert 2dry batteries AAA.LR03 (alkaline).
3. Replace the front cover.
To x the remote controller holder to a wall
1. Choose a place from where the signals reach
the unit.
2. Fix the holder to a wall, a pillar, or similar
location with the screws supplied with the
holder.
3. Place the remote controller in the remote
controller holder.
Turn on the circuit breaker
•Afterthepoweristurnedon,theapsoftheindoorunitopenandcloseoncetosetthe
referenceposition.
Position and
correctly!
+
–
2
3
1
Remote
controller holder
Remote controller
Screws
NOTE
Notes on batteries
•Whenreplacingthebatteries,usebatteriesofthesametype,andreplacebotholdbatteriestogether.
•Thebatterieswilllastforabout1year.Iftheremotecontrollerdisplaybeginstofadeandthepossibletransmissionrangebecomesshorterwithin
ayear,however,replacebothbatterieswithnew,sizeAAA.LR03(alkaline).
•Thebatteriessuppliedwiththeremotecontrollerareforinitialoperation.Thebatteriesmayrunoutinlessthan1year.
Note on remote controller
•Donotdroptheremotecontroller.Donotgetitwet.
01_EN_3P384084-2.indd 9 11/4/2014 2:09:40 PM