Daikin FTKM33NV2S User Manual

REMOVAL
PROCEDURE
SERVICE MANUAL
Indoor Unit
Inverter / Non-Inverter
Wall Mounted Type
6.0/7.0/7.1/8.0/8.5/9.0/9.5 kW Class
28000/30000/32000/33000/36000 Btu/h Class
Si041352ED

Daikin FTKM33NV2S Specifications

General

Cooling Capacity	3.3 kW
Refrigerant	R32
Noise Level (Outdoor)	48 dB(A)
Seasonal Energy Efficiency Ratio (SEER)	6.1
Power Supply	230V, 50Hz, 1 Phase

Summary

Air Filters and Front Panel Removal

Remove Front Panel

Electrical Box Removal

Initial Electrical Box Removal Steps

Removing screws, drip proof plate, and earth/ground wire from the electrical box area.

Disconnecting Thermistor and Terminal Strip

Steps for removing thermistor, wire fixture, terminal strip, and ferrite core.

Final Electrical Box Removal and Disconnection

Disconnecting connectors, releasing harness, and removing the electrical box unit.

PCBs Removal Procedures

Remove Signal Receiver PCB Assembly

Procedure to unfasten hooks and open the shield plate for PCB removal.

Release Harnesses for Signal Receiver

Remove Intelligent Eye Sensor PCB

Remove Display PCB

Remove Control PCB

Swing Motors Removal

Remove Horizontal Blade Swing Motors

Steps to remove horizontal blade swing motors, including loosening screws.

Release Interlock Rod and Drain Hose

Remove Motor Pivots and Connectors

Remove Vertical Blade Swing Motor (Link Cover, Rods)

Remove Vertical Blade Swing Motor (Screws, Connector)

Fan Motor Removal (Without Heat Exchanger)

Remove Fan Motor and Vibration Absorber

Indoor Heat Exchanger Removal

Prepare for Heat Exchanger Removal

Disconnecting drain hose, piping, and detaching the indoor unit from the installation plate.

Release Piping Fixture and Auxiliary Piping

Releasing piping fixtures, auxiliary piping, and removing screws/hooks.

Final Indoor Heat Exchanger Removal

Final steps to lift and remove the indoor heat exchanger assembly.

Fan Motor and Fan Rotor Removal

Remove Fan Motor and Fan Rotor