Instruction SiENBE12-713
218 System Configuration
For programming TEMPERATURE, FAN SPEED and AIR
FLOW DIRECTION, follow the procedure shown below.
Temperature setting
Press TEMPERATURE SETTING button and program the
setting temperature.
Each time this button is pressed, setting
temperature rises 1°C
Each time thus button is pressed, setting
temperature lowers 1°C
• The setting is impossible for fan operation.
NOTE
• The setting temperature range of the remote control is
16°C to 32°C.
Fan speed control
Press FAN SPEED CONTROL button.
High or Low fan speed can be selected.
Micro computer may sometimes control the fan speed in order
to protect the unit.
Air flow direction adjust
There are 2 ways of adjusting the air discharge angle.
1. A. up and down adjustment
2. B. Left and right direction
A.UP AND DOWN DIRECTION.
• The movable limit of the flap is changeable.
Contact your Daikin dealer for details.
Press the AIR FLOW DIRECTION ADJUST button
to select the air direction as following.
The AIR FLOW FLAP display swings as
shown left and the air flow direction
continuously varies. (Automatic swing
setting)
Press AIR FLOW DIRECTION ADJUST
button to select the air direction of your
choice.
The AIR FLOW FLAP display stops
swinging and the air flow direction is fixed
(Fixed air flow direction setting).
Movement of the air flow flap
For the following conditions, micro computer controls the air
flow direction so it may be different from the display.
Operation mode includes automatic operation.
A.UP AND RIGHT DIRECTION.
• Adjusting air flow direction in the left and right
direction.
(Refer to fig. 1)
NOTE
• Only make adjusment after you have stopped the air flow
direction swing in a position where adjustments are
possible.Your hand may get caught if you attempt to make
adjustments while the unit is swinging.
Adjustment
Fig. 1
A. Up and down
direction
B. Left and right direction
Operation
mode
Cooling Heating
Operation
condition
• When room
temperature is
higher than the set
temperature
• When room
temperature is set
higher than the set
temperature
• At defrost
operation
• When operating continuously at downward
air flow direction
swing
To Next Page
Loading...
