Daikin FTKS71JVMG9 User Manual

REMOVAL
PROCEDURE
SERVICE MANUAL
Indoor Unit
Inverter / Non-Inverter
Wall Mounted Type
6.0/7.0/7.1/8.0/8.5/9.0/9.5 kW Class
28000/30000/32000/33000/36000 Btu/h Class
Si041352ED

Daikin FTKS71JVMG9 Specifications

General

Cooling Capacity	7.1 kW
Heating Capacity	8.0 kW
Indoor Unit Dimensions (W x H x D)	990 x 298 x 263 mm
Outdoor Unit Dimensions (W x H x D)	840 x 595 x 300 mm
Power Supply	220-240 V, 50 Hz

Summary

Air Filters / Front Panel

Remove Front Panel

Steps to remove the front panel by releasing shafts and hooks.

Electrical Box

Remove Thermistor, Harness, and Ferrite Core

Steps to remove thermistor, wire fixture, terminal strip, and ferrite core.

Disconnect Harness and Remove Electrical Box

Steps to disconnect harness, remove screw, and lift out electrical box.

PCBs

Remove Signal Receiver Unit

Steps to release harness, unfasten hooks, and remove the signal receiver unit.

Remove Display and Control PCBs

Steps to remove display PCB and control PCB by unfastening hooks and disconnecting connectors.

Swing Motors

Release Interlock Rod and Remove Swing Motor Unit

Release interlock rod, remove screw, and detach swing motor unit.

Remove Horizontal Swing Motors and Disconnect Connectors

Fan Motor (Without Removing Indoor Heat Exchanger)

Remove Upper Fan Motor Fixing Plate

Remove Lower Fixing Plate, Fan Motor, and Vibration Absorber

Remove lower fixing plate, fan motor, and vibration absorber.

Indoor Heat Exchanger

Disconnect Drain Hose and Piping

Remove Indoor Heat Exchanger

Lift up and remove the indoor heat exchanger unit.

Fan Motor / Fan Rotor

Remove Fan Motor and Fan Rotor

Loosen fan rotor screw, remove fan motor and fan rotor.