Outdoor Unit SiENBE12-713
302 Removal Procedure
4
Undo the 3 hooks on
the reactor side and
slide the control PCB.
5
Undo the relay harness
for compressor from the
hook.
6
Lift up the control PCB
to remove.
" In working, be careful not to
break the control PCB with
the excessive force because
the PCB and the radiation fin
are adhered to one another.
" When assembling, make
sure to use the silicon
material.
" Silicon material
Part No.: 1172698
7
Each wire harness.
Step
Procedure Points
Compressor relay harness
Earth wire
To Next Page
Loading...
