Need help?Do you have a question about the Daikin FTNE25MV1 and is the answer not in the manual?
General| Brand | Daikin |
|---|---|
| Model | FTNE25MV1 |
| Category | Air Conditioner |
| Language | English |
Procedure to remove the air filters by opening the front panel to its stopping position.
Procedure to remove the front panel by pushing shafts towards the inside to release it.
Procedure to prepare the front grille for removal by unscrewing and unfastening its hooks.
Final step to detach the front grille after all fasteners are released.
Procedure to detach horizontal blades by unfastening shafts and slightly bending them.
Procedure to remove vertical blade assemblies by unfastening their respective hooks.
Procedure to remove the main electrical box by disconnecting wires and screws.
Procedure to remove the shield plate and the electrical box cover.
Procedure to disconnect connectors and remove signal receiver and control PCBs.
Procedure to detach the swing motor by removing its mounting screws.
Steps to remove screws, disconnect drain hose, and prepare piping.
Procedure to detach the indoor unit from its installation plate.
Procedure to unfasten the piping fixture and pull out the auxiliary piping.
Procedure to unfasten hooks on both sides and remove the indoor heat exchanger.
Procedure to remove screws and unfasten the hook to detach the right side plate.
Procedure to loosen the screw and remove the fan motor and fan rotor.
Procedure to remove the left side plate and the bearing.
To Next Page
