Titanium apatite deodorizing fi lter
1. Open the front panel and
pull out the air fi lters.
Page 24
2. Take off the titanium apatite
deodorizing fi lters.
• Hold the recessed parts of the frame and unhook
the 4 claws.
ClawClaw
3. Clean or replace the
titanium apatite deodorizing
fi lters.
[Cleaning]
3-1 Vacuum dust, and soak in lukewarm
water or water for about 10 to
15 minutes if very dirty.
3-2 After washing, shake off remaining
water and let them dry in the shade.
• Do not wring out the fi lter to remove water from it.
[Replacement]
Remove the fi lter from the fi lter
frame and prepare a new one.
• Do not throw away the fi lter frame. Reuse the fi lter
frame when replacing the titanium apatite
deodorizing fi lter.
• Dispose of the old fi lter as non-fl ammable waste.
4. Insert the titanium apatite
deodorizing fi lters as they
were.
• When attaching the fi lter, check that the fi lter is
properly set in the tabs.
5. Reattach the fi lters.
Page 24
6. Close the front panel
slowly.
Page 24
NOTE
• Operation with dirty fi lters:
− cannot deodorize the air,
− cannot clean the air,
− results in poor heating or cooling,
− may cause odor.
• Dispose of old fi lters as non-fl ammable waste.
• To order a titanium apatite deodorizing fi lter, contact the dealer
where you bought the air conditioner.
Item Titanium apatite deodorizing fi lter 1 set
Part No. KAF970A46
Care and Cleaning
■ FTX50K2V1B / FTX60K2V1B / FTX71K2V1B
■ FTXP50K3V1B / FTXP60K3V1B/ FTXP71K3V1B
25
Care