What to do if my Daikin FTXG25CVMAW Air Conditioner stops and the operation lamp flashes?
If your Daikin Air Conditioner stops suddenly and the OPERATION lamp flashes, clean the air filters or remove any obstacles. Then, turn the breaker OFF, turn it ON again, and try operating the air conditioner with the remote controller.
Why did my Daikin FTXG25CVMAW Air Conditioner stop suddenly but the operation lamp is on?
If your Daikin Air Conditioner stops suddenly but the OPERATION lamp is on, it may be due to a sudden large voltage fluctuation for system protection. The unit will automatically resume operation in about 3 minutes.
What to do if my Daikin FTXG25CVMAW smells like burning?
If your Daikin Air Conditioner is emitting a burning smell, turn the breaker OFF and call the service shop immediately.
How to get rid of the odor from the indoor unit of my Daikin FTXG25CVMAW?
If your Daikin Air Conditioner's indoor unit is emitting an odor, it's recommended to have the indoor unit professionally cleaned by a technician. Contact the service shop where you purchased the air conditioner to arrange for this service.
How to get rid of bad smell from my Daikin FTXG25CVMAW Air Conditioner?
If the indoor unit of your Daikin Air Conditioner gives out an odor, it is recommended to have the indoor unit washed by a technician.
Why isn't my Daikin Air Conditioner blowing hot air right away?
If hot air does not flow out soon after the start of heating operation of your Daikin Air Conditioner, you should wait for 1 to 4 minutes.
Why is my Daikin Air Conditioner not cooling or heating properly?
If the cooling or heating effect of your Daikin Air Conditioner is poor, check if the air filters are clean, if there is anything blocking the air inlet or outlet, if the temperature setting is appropriate, if the windows and doors are closed, if the air flow rate and direction are set appropriately, and if the unit is set to the INTELLIGENT EYE mode.
Why is my Daikin Air Conditioner malfunctioning?
If an abnormal functioning happens during operation of your Daikin Air Conditioner, it may be due to lightning or radio waves. Turn the breaker OFF, turn it ON again, and try operating the air conditioner with the remote controller.
What to do if a button on my Daikin FTXG25CVMAW Air Conditioner remote is not working?
If a switch or a button on your Daikin Air Conditioner often fails to work properly, turn the breaker OFF and call the service shop.
What to do if my Daikin FTXG25CVMAW Air Conditioner stops suddenly and the operation lamp flashes?
If your Daikin Air Conditioner suddenly stops and the OPERATION lamp is flashing, try these steps: Begin by cleaning the air filters to remove any accumulated dust or debris. Make sure there are no obstructions blocking the unit. After addressing these issues, turn the breaker OFF, wait a moment, and then turn it back ON. Finally, attempt to operate the air conditioner again using the remote controller.
General| Cooling Capacity | 2.5 kW |
|---|---|
| Heating Capacity | 3.2 kW |
| Power Supply | 220-240V, 50Hz |
| Refrigerant | R32 |
| Outdoor Unit Dimensions (HxWxD) | 550 x 765 x 285 mm |
| Outdoor Unit Weight | 32 kg |
| Indoor Unit Noise Level (Cooling/Low) | 19 dBA |
| Outdoor Unit Noise Level | 46 dB(A) |
| Type | Split System Air Conditioner |
Guide to initiating, halting, and adjusting the desired temperature for various operation modes.
How to select and adjust the fan speed for different operation modes, including quiet operation.
Instructions for controlling the direction of air discharge using the horizontal flap and vertical louvers.
How to activate 3-D airflow for room-wide circulation and Comfort airflow for direct air avoidance.
Steps to engage the Powerful mode for rapid cooling or heating and how to cancel it.
How to activate the Outdoor Unit Silent mode to reduce noise levels, and how to turn it off.
Procedure for turning the Intelligent Eye sensor on and off for energy-saving operation.
Symptom indicators that require immediate professional service for the air conditioner.
To Next Page
