28
Service & Maintenance
Front Panel Opening & Closing Sequence (FTXS-A series)
To open the front panel
1) Lift up the two tips of front panel A until it stops at the pre-x position.
2) Lift up the two tips of front panel B to open it anda access to inner parts.
To close the front panel, reverse the steps of opening sequence. Slot in the ribs (4 ribs at each side, total 8
ribs), carefully at both left and right. Then, press the panel forward till it closes tight. Refer to C
Step 1 Step 2
Step 3 Step 3
• Don’t touch the metal parts of the indoor unit. It may cause an injury.
• When removing or attaching the front panel, use a robust and stable stool and watch your steps carefully.
• When removing or attaching the front panel, support the panel securely with hand to prevent from it falling.
• For cleansing, do no use hot water above 40°C, benzene, gasoline, thinner, nor other volatile oils, polishing
compound, scrubbing brushes, nor other hand stuff.
• After cleaning, make sure that the front panel is securely xed.
To Next Page
Loading...
