Daikin FTXS20G2V1B User Manual (English)

Other manuals for Daikin FTXS20G2V1B

Operation Manual38 pages

Service Manual316 pages

Installation Manual15 pages

Questions and Answers:

C
Christopher MorganJul 31, 2025
Why is the cooling or heating effect poor on my Daikin FTXS20G2V1B Air Conditioner?
- J
  Jason BallJul 31, 2025
  If your Daikin Air Conditioner's cooling or heating effect is poor, check the following: * Ensure the air filters are clean. * Make sure nothing is blocking the air inlet or outlet of the indoor and outdoor units. * Verify the temperature setting is appropriate. * Confirm that all windows and doors are closed. * Check that the airflow rate and air direction are set correctly.
C
Clayton DavidsonAug 4, 2025
What to do if my Daikin FTXS20G2V1B has an abnormal functioning during operation?
- D
  Darrell RiceAug 5, 2025
  If your Daikin Air Conditioner experiences an abnormal functioning during operation, turn the breaker OFF, then turn it ON again. After that, try operating the air conditioner with the remote controller.
J
Joseph AllenAug 10, 2025
How to troubleshoot a Daikin FTXS20G2V1B Air Conditioner that does not operate?
- A
  athompsonAug 10, 2025
  If your Daikin Air Conditioner does not operate and the OPERATION lamp is off, check the following: * Ensure that a breaker hasn’t turned OFF or a fuse hasn’t blown. * Confirm that there isn’t a power failure. * Verify that batteries are properly installed in the remote controller. * Check if the timer setting is correct.
S
Stephanie KentAug 14, 2025
What to do if my Daikin Air Conditioner indoor unit stops in heat pump mode?
- W
  William HillAug 15, 2025
  If your Daikin heat pump model indoor unit stops or doesn't operate when the heat pump model is selected, it may be due to the unit being in cooling, dry, or fan operation mode, which will cause it to stop if the heating mode is selected. If the unit is not in operation and the Run button is pressed while in heating mode, the unit will not start. Check the specifications of the outdoor unit. If it is a cooling-only model, set the remote controller for a cooling-only model using the cooling-only/heat pump switch.
J
Jessica RomeroAug 20, 2025
Why can't I select heating on my Daikin Air Conditioner?
- L
  Laura SellersAug 20, 2025
  To enable heating on your Daikin unit, set the remote controller for heat pump model using the cooling only/heat pump switch on the remote controller.
C
Charles WebbAug 26, 2025
What to do if my Daikin FTXS20G2V1B stops suddenly and the operation lamp flashes?
- G
  Gerald LarsenAug 26, 2025
  If your Daikin Air Conditioner operation stops suddenly and the OPERATION lamp is flashing, first ensure the air filters are clean and that nothing is blocking the air inlet or outlet of either the indoor or outdoor units. Clean the filters or remove any obstructions, then turn the breaker OFF and back ON. Try operating the air conditioner with the remote controller again. If the lamp continues to flash, it is recommended to contact the shop where you purchased the air conditioner. Also, if you are using a multi-system, ensure all indoor units connected to the outdoor units are set to the same operation mode.

Daikin FTXS20G2V1B Specifications

General

Cooling Capacity	2.0 kW
Heating Capacity	2.5 kW
Power Supply	220-240V, 50Hz
Star Rating	5 Star
Indoor Unit Weight	9 kg
Refrigerant	R410A
Indoor Unit Noise Level	19 dB(A)