13
■ To start 3-D Airflow
1. 3. Press the “SWING button ” and the “SWING button ”:
the “ ” and “ ” display will light up and the flap and louvers will
move in turn.
■ To cancel 3-D Airflow
2. 4. Press either the “SWING button ” or the “SWING button ”.
■ COMFORT AIRFLOW operation
• Check COMFORT AIRFLOW operation in the section of “COMFORT AIRFLOW Operation”
and “INTELLIGENT EYE Operation”. (page 14.)
Notes on flaps and louvers angles
• When “
SWING button
” is selected, the flaps
swinging range depends on the operation
mode. (See the figure.)
Three-Dimensional (3-D) Airflow
• Using three-dimensional airflow circulates
cold air, which tends to collected at the bottom
of the room, and hot air, which tends to collect
near the ceiling, throughout the room,
preventing areas of cold and hot developing.
■
ATTENTION
• Always use a remote controller to adjust the
angles of the flaps and louvers. If you
attempt to move it forcibly with hand when it
is swinging, the mechanism may be broken.
• Always use a remote controller to adjust the
louvers angles. In side the air outlet, a fan is
rotating at a high speed.
5˚
80˚
5˚
15˚
50˚
80˚
30˚
70˚
In DRY mode or
COOL mode
Upper limit
COMFORT AIRFLOW
(page 14.)
COMFORT AIRFLOW (page 14.)
Lower limit
Stop operation
Upper limit
Lower limit
Upper limit
Lower limit
In HEAT mode
In FAN mode
Stop operation
Stop operation
01_EN_3P207037-1.fm Page 13 Monday, September 10, 2007 5:16 PM
To Next Page
Loading...
